*Please select the year of your car when ordering along with the options you want to add on. A shaft extension is required for the two speed or delay switch to mount the switch in the stock location and use the stock knob. Motor mounts in the stock location and operates through the OEM cables. Motor mounts in the stock location under the dash using stock linkage and transmissions. Clears stock cowl vent and air conditioning.Each kit comes complete with nylon bushings to replace the rubber grommets in the wiper transmission linkage arms (when required).If your vehicle is 6 volt, you will need a power inverter or to convert your vehicle to 12 volt Wiper drives attach to the stock mounting brackets.Each model of the clean wipe wiper drive is designed for the specific year and model of the vehicle. The clean wipe wiper drive is a true bolt-in replacement for your original equipment vacuum or electric windshield wiper motor. Before removing the wiper motor review the article at Car Tech, Body/Suspension/ Steering, the third article from the bottom titled “How to Improve Windshield Wiper Function”.New Port Engineering 12 Volt Wiper Motors for Ford Thunderbird After the control cable is removed the wiper motor can be removed from under the dash. More recent service between 2001-2006 included all new Pertonix ignition system, alternator upgrade, replacement gas tank, new Holley carburetor, resealed. The 1960s saw sharper-edged lines for the body, but under the hood remained. 5- You can now drop the wiper motor down enough to remove the control cable retainer. Get multiple, competitive, instant windshield replacement auto glass quotes. Bracket P/N 17496 will remain attached to the body of the car. 4- Remove motor retainer screws from motor mount bracket P/N 17496. The rubber grommets P/N 17562 will remain in the ends of the wiper arms. 3- Push the arms P/N 17566 RH & 17567 LH off the wiper motor arm studs. 2-Remove arm retainer spring P/N 17450, pull up on the spring and it will release from the wiper motor arm retainer studs, being careful not drop the spring. 1- Disconnect the vacuum hose to wiper motor P/N 17543, it is not clamped and should pull off. Once you are under the dash and have located the wiper motor it can be removed by following the steps below. Access to the wiper motor can be enhanced by removing the seat but is not necessary. The 12V power supply to the A/C unit must be disconnected. The A/C unit hoses do not require removal. These pieces will lock over the edge of the glass with the rubber between the pieces. You also need to put the 2 upper retainers into the seal before installation. You will have to work it to get the back of the glass and stainless steel trim up so you can see two small screws that hold the stainless trim and window regulator together. If the car is equipped with an under-dash air conditioner the evaporator must be dropped down and push to the side. Make sure to put the 2 lower pieces of stainless trim into the weatherstrip before putting the windshield into the opening or it cannot be installed later. The wiper motor can be removed and replaced from under the dash. The windshield vacuum wiper motor is mounted to a bracket P/N 17496, near the center of the upper portion of the firewall under the dash.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |